Every ranch place in Talmage collects concrete that has outlived its purpose. A pad for a grain bin that came down years ago. Steps that heaved and cracked until nobody trusts them. A barn apron broken into chunks that tip when a horse steps on them. At some point patching stops making sense and the best move is to get it out.
We break up the concrete, cut back to a clean edge where part of a slab is staying, pull out any rebar or wire mesh, and haul the debris away. Then we clean up the area so it’s ready for a new pour, gravel, or grass. We’ll talk through what’s under the slab and what comes next before we start, so there are no surprises once the concrete is gone.
We know Talmage ranch properties, from old bin pads in the weeds to barn aprons sitting near waterlines and corrals.
Breakers, concrete saws, loaders, and haul trucks sized for everything from a single stoop to a full shop apron come on each trip.
If your concrete can be repaired instead of removed, we'll say so before you pay to have it broken out.
We protect fences, lawns, and stock waterers, haul every load of rubble, and leave the ground raked and tidy.
Not every crack means a slab is finished. Repair is usually the cheaper route when the concrete is mostly sound. Removal makes sense when the damage goes all the way through or the slab is simply in the way. Here’s what usually tips the decision:
If you’re unsure, we’ll look with you and give you an honest call. When the concrete is worth saving, repairing cracked Talmage concrete costs far less than tearing it out.
Talmage was settled in 1907 and platted as Winn in 1912, so some properties have layers of history in the ground. It’s common to find concrete from old sheds, pump houses, or bin pads tucked in the weeds near corrals and hay ground. Those slabs get in the way of new buildings, fences, or simply a mower.
Barn aprons are another big one. Years of loaded trucks and livestock traffic can break an apron into slabs that shift and trap water. Removing it gives you a chance to fix the grade and drainage before something new goes in. A lot of apron problems start with water pooling at the barn door, and pulling the old slab is the one time it’s easy to correct that.
Often only part of a slab needs to go. A broken section of walk, a corner of a shop apron, or one set of steps can come out while the rest stays. We saw cut a straight line first so the concrete that stays has a clean, square edge instead of a jagged break.
That clean edge matters when new concrete is being poured against it later. It gives the flatwork contractor a solid face to tie into and makes the finished joint look intentional. Without a saw cut, breaking out one section can crack the slab beside it, and then you’re paying to replace more than you planned.
Broken concrete is heavy, and a lot of it gets surprisingly bulky once it’s in chunks. We load it, haul it off, and separate rebar and mesh from the rubble when we can. You won’t be left with a pile behind the barn to deal with later.
If the removal is part of a bigger cleanup, debris hauling from Talmage properties can take away old lumber, fencing, and scrap at the same time so the drive out covers more ground.
Most slab removal stays at the surface, but taking out footings, deep pads, or anything set in the ground means digging. Utah Blue Stakes requires a call at least 3 business days before digging, and whoever does the digging makes that call. Tickets expire after 21 days, so timing matters on a planned trip.
Waterlines to stock tanks and hydrants often run close to old slabs on ranch properties. We’ll ask what you know about the lines on your place and work carefully around them. Private lines like those aren’t always marked by Blue Stakes, so anything you can tell us about where they run helps a lot.
Once the concrete is gone, the ground underneath usually needs some shaping. Basin doesn’t pour new concrete, but we can rough level the area so it’s ready for a flatwork contractor, gravel, or seed.
For a new driveway or apron, grading to set slope and drainage keeps water moving away from the barn or house. Talmage is far out on our route, so we plan these trips ahead and line up the removal and dirt work together whenever possible.
We look at the concrete, check access for equipment, and ask about waterlines and anything buried near the slab.
You get a free written quote that covers breakout, saw cutting, hauling, and cleanup for each area.
We saw cut any edges that stay, break up the concrete, pull the rebar, and haul all debris off your property.
We walk the cleared area with you, confirm everything's been hauled, and talk through next steps for the ground.
