Concrete looks solid, but it’s full of tiny pores that soak up water. In Vernal, that water freezes overnight in winter, expands, and slowly breaks down the surface. Add ice melt and road salt tracked in from Main Street and Highway 40, and unsealed concrete starts to scale, flake, and crack years before it should. Strong sun at over 5,000 feet also fades and dries out exposed surfaces.
Sealing fills those pores so water and salt can’t soak in as easily. We clean the surface, fix cracks and problem spots, and apply a sealer suited to the job, whether that’s a penetrating sealer for a driveway or a coating for a garage floor or patio. The result is concrete that sheds water, resists stains, and lasts longer between repairs.
We know how Basin winters, snowmelt, and ice melt wear down concrete and time sealing for the right weather.
Pressure washers, sprayers, and rollers to clean and seal driveways, patios, and floors.
We'll recommend the right sealer for your surface and tell you if repairs are needed first.
We protect nearby surfaces, block off the area while it cures, and leave everything clean.
Concrete sealing is basically a raincoat for your slab. Concrete is porous, so water, slush, and oil soak right into it. A sealer either fills those pores from the inside or forms a thin film on top, and either way it cuts down on how much moisture and salt can get in. Less water inside the concrete means less damage when that water freezes.
What sealing won’t do is fix damage that’s already there. It won’t close a crack, level a sunken panel, or rebuild a flaked surface. Think of it as protection for concrete that’s still in decent shape, or the final step after repairs are done.
The high desert is hard on concrete in ways people don’t always expect. Vernal only gets around 9 inches of precipitation a year, but snow sits on driveways and walks for days, melts in the afternoon sun, and refreezes every night. Each round pushes water deeper into an unsealed slab.
Then there’s the sun. At more than 5,000 feet in the Ashley Valley, UV is stronger than it is at lower elevations, and it breaks down topical sealers and fades color faster. Summer highs in the mid 80s, with some days over 100, bake the surface, and winter lows near 10 degrees shrink it back down. That swing is a big reason sealer doesn’t last forever here.
A sealer is only as good as the surface under it, so most of the work happens before anything goes on. Here’s how a typical job runs. We start with a thorough cleaning, and pressure washing lifts dirt, tire marks, and old buildup out of the pores so the sealer can actually soak in.
Next we let the slab dry fully. Sealing damp concrete traps moisture and can leave a cloudy, white haze. Then we deal with cracks and damaged spots, apply the sealer in thin, even coats, and keep traffic off while it cures. Rushing any one of those steps shows up later.
Penetrating sealers soak into the concrete and react inside it. They don’t change the look much, they don’t get slick, and they hold up well to traffic and sun. For most driveways and sidewalks that see snow and ice melt, they’re our usual pick.
Topical sealers sit on the surface and can add a wet look or a light sheen. They’re great on patios, stained concrete, and covered porches where you want color to pop. They do wear faster in direct sun and under tires, so they need refreshing more often. We’ll match the product to how the surface is used, not just how you want it to look on day one.
Not sure if your concrete is still protected? Walk it after a rain or a sprinkler run and look for these:
If any of those sound familiar, it’s time for a fresh coat. If you’re also seeing cracks or broken edges, concrete repair should come first so the sealer goes over a sound surface.
Sealing does the most good when it’s paired with smart winter care. Shovel or plow early so snow doesn’t get packed down and turn to ice. Clear slush off the garage floor before it sits there for days. Keep downspouts pointed away from walks and driveways.
Your choice of de-icer matters too. Rock salt slows down a lot once temps drop into the low teens, so people tend to pile on more, and that extra salt sits on the slab. Calcium or magnesium chloride blends work at colder temps, and sand gives you traction without adding more chemicals. If you’d rather not deal with it yourself, our de-icing and salt application crew can handle it for homes and businesses around Vernal, Naples, and Maeser.
We look at your concrete, check for damage, and talk about how the area is used.
You get a written quote covering cleaning, repairs, sealer type, and timing.
We clean, fix cracks, and apply the sealer evenly across the whole surface.
We walk the finished work with you and let you know when it's ready for traffic.
